36 lines
1.5 KiB
Plaintext
36 lines
1.5 KiB
Plaintext
|
Mediatek MT7621 SoC GPIO controller bindings
|
||
|
|
|
||
|
|
The IP core used inside these SoCs has 3 banks of 32 GPIOs each.
|
||
|
|
The registers of all the banks are interwoven inside one single IO range.
|
||
|
|
We load one GPIO controller instance per bank. Also the GPIO controller can receive
|
||
|
|
interrupts on any of the GPIOs, either edge or level. It then interrupts the CPU
|
||
|
|
using GIC INT12.
|
||
|
|
|
||
|
|
Required properties for the top level node:
|
||
|
|
- #gpio-cells : Should be two. The first cell is the GPIO pin number and the
|
||
|
|
second cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>.
|
||
|
|
Only the GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported.
|
||
|
|
- #interrupt-cells : Specifies the number of cells needed to encode an
|
||
|
|
interrupt. Should be 2. The first cell defines the interrupt number,
|
||
|
|
the second encodes the triger flags encoded as described in
|
||
|
|
Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
|
||
|
|
- compatible:
|
||
|
|
- "mediatek,mt7621-gpio" for Mediatek controllers
|
||
|
|
- reg : Physical base address and length of the controller's registers
|
||
|
|
- interrupt-parent : phandle of the parent interrupt controller.
|
||
|
|
- interrupts : Interrupt specifier for the controllers interrupt.
|
||
|
|
- interrupt-controller : Mark the device node as an interrupt controller.
|
||
|
|
- gpio-controller : Marks the device node as a GPIO controller.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
gpio@600 {
|
||
|
|
#gpio-cells = <2>;
|
||
|
|
#interrupt-cells = <2>;
|
||
|
|
compatible = "mediatek,mt7621-gpio";
|
||
|
|
gpio-controller;
|
||
|
|
interrupt-controller;
|
||
|
|
reg = <0x600 0x100>;
|
||
|
|
interrupt-parent = <&gic>;
|
||
|
|
interrupts = <GIC_SHARED 12 IRQ_TYPE_LEVEL_HIGH>;
|
||
|
|
};
|