35 lines
1.3 KiB
Plaintext
35 lines
1.3 KiB
Plaintext
|
Microchip PIC32 SPI Master controller
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: Should be "microchip,pic32mzda-spi".
|
||
|
|
- reg: Address and length of register space for the device.
|
||
|
|
- interrupts: Should contain all three spi interrupts in sequence
|
||
|
|
of <fault-irq>, <receive-irq>, <transmit-irq>.
|
||
|
|
- interrupt-names: Should be "fault", "rx", "tx" in order.
|
||
|
|
- clocks: Phandle of the clock generating SPI clock on the bus.
|
||
|
|
- clock-names: Should be "mck0".
|
||
|
|
- cs-gpios: Specifies the gpio pins to be used for chipselects.
|
||
|
|
See: Documentation/devicetree/bindings/spi/spi-bus.txt
|
||
|
|
|
||
|
|
Optional properties:
|
||
|
|
- dmas: Two or more DMA channel specifiers following the convention outlined
|
||
|
|
in Documentation/devicetree/bindings/dma/dma.txt
|
||
|
|
- dma-names: Names for the dma channels. There must be at least one channel
|
||
|
|
named "spi-tx" for transmit and named "spi-rx" for receive.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
|
||
|
|
spi1: spi@1f821000 {
|
||
|
|
compatible = "microchip,pic32mzda-spi";
|
||
|
|
reg = <0x1f821000 0x200>;
|
||
|
|
interrupts = <109 IRQ_TYPE_LEVEL_HIGH>,
|
||
|
|
<110 IRQ_TYPE_LEVEL_HIGH>,
|
||
|
|
<111 IRQ_TYPE_LEVEL_HIGH>;
|
||
|
|
interrupt-names = "fault", "rx", "tx";
|
||
|
|
clocks = <&PBCLK2>;
|
||
|
|
clock-names = "mck0";
|
||
|
|
cs-gpios = <&gpio3 4 GPIO_ACTIVE_LOW>;
|
||
|
|
dmas = <&dma 134>, <&dma 135>;
|
||
|
|
dma-names = "spi-rx", "spi-tx";
|
||
|
|
};
|