34 lines
1.5 KiB
C
34 lines
1.5 KiB
C
|
/* SPDX-License-Identifier: GPL-2.0 */
|
||
|
|
/*
|
||
|
|
* Standard pin control state definitions
|
||
|
|
*/
|
||
|
|
|
||
|
|
/**
|
||
|
|
* @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
|
||
|
|
* into as default, usually this means the pins are up and ready to
|
||
|
|
* be used by the device driver. This state is commonly used by
|
||
|
|
* hogs to configure muxing and pins at boot, and also as a state
|
||
|
|
* to go into when returning from sleep and idle in
|
||
|
|
* .pm_runtime_resume() or ordinary .resume() for example.
|
||
|
|
* @PINCTRL_STATE_INIT: normally the pinctrl will be set to "default"
|
||
|
|
* before the driver's probe() function is called. There are some
|
||
|
|
* drivers where that is not appropriate becausing doing so would
|
||
|
|
* glitch the pins. In those cases you can add an "init" pinctrl
|
||
|
|
* which is the state of the pins before drive probe. After probe
|
||
|
|
* if the pins are still in "init" state they'll be moved to
|
||
|
|
* "default".
|
||
|
|
* @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
|
||
|
|
* when the pins are idle. This is a state where the system is relaxed
|
||
|
|
* but not fully sleeping - some power may be on but clocks gated for
|
||
|
|
* example. Could typically be set from a pm_runtime_suspend() or
|
||
|
|
* pm_runtime_idle() operation.
|
||
|
|
* @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
|
||
|
|
* when the pins are sleeping. This is a state where the system is in
|
||
|
|
* its lowest sleep state. Could typically be set from an
|
||
|
|
* ordinary .suspend() function.
|
||
|
|
*/
|
||
|
|
#define PINCTRL_STATE_DEFAULT "default"
|
||
|
|
#define PINCTRL_STATE_INIT "init"
|
||
|
|
#define PINCTRL_STATE_IDLE "idle"
|
||
|
|
#define PINCTRL_STATE_SLEEP "sleep"
|