42 lines
1.4 KiB
Plaintext
Executable file
42 lines
1.4 KiB
Plaintext
Executable file
IFM camera sensor interface on mpc5200 LocalPlus bus
|
|
|
|
Required properties:
|
|
- compatible: "ifm,o2d-csi"
|
|
- reg: specifies sensor chip select number and associated address range
|
|
- interrupts: external interrupt line number and interrupt sense mode
|
|
of the interrupt line signaling frame valid events
|
|
- gpios: three gpio-specifiers for "capture", "reset" and "master enable"
|
|
GPIOs (strictly in this order).
|
|
- ifm,csi-clk-handle: the phandle to a node in the DT describing the sensor
|
|
clock generator. This node is usually a general purpose timer controller.
|
|
- ifm,csi-addr-bus-width: address bus width (valid values are 16, 24, 25)
|
|
- ifm,csi-data-bus-width: data bus width (valid values are 8 and 16)
|
|
- ifm,csi-wait-cycles: sensor bus wait cycles
|
|
|
|
Optional properties:
|
|
- ifm,csi-byte-swap: if this property is present, the byte swapping on
|
|
the bus will be enabled.
|
|
|
|
Example:
|
|
|
|
csi@3,0 {
|
|
compatible = "ifm,o2d-csi";
|
|
reg = <3 0 0x00100000>; /* CS 3, 1 MiB range */
|
|
interrupts = <1 1 2>; /* IRQ1, edge falling */
|
|
|
|
ifm,csi-clk-handle = <&timer7>;
|
|
gpios = <&gpio_simple 23 0 /* image_capture */
|
|
&gpio_simple 26 0 /* image_reset */
|
|
&gpio_simple 29 0>; /* image_master_en */
|
|
|
|
ifm,csi-addr-bus-width = <24>;
|
|
ifm,csi-data-bus-width = <8>;
|
|
ifm,csi-wait-cycles = <0>;
|
|
};
|
|
|
|
The base address of the used chip select is specified in the
|
|
ranges property of the parent localbus node, for example:
|
|
|
|
ranges = <0 0 0xff000000 0x01000000
|
|
3 0 0xe3000000 0x00100000>;
|